How to operate a used placement machine:

1. Fill in the [Equipment Daily Inspection Form] check item by item before operating the second-hand placement machine. Yamaha placement machine should do the daily maintenance maintenance of the equipment; check whether the equipment is complete, notify the engineer if there is any missing.

2. Test the vacuum height of the nozzle before production. When you need to replace, turn off the servo motor switch; push the cantilever type by hand, first check whether the feeder on the device is abnormal the Z axis of the rotary head is at the upper end.

3. It is strictly forbidden to put your hands foreign objects into the equipment during the production process. Do press the emergency stop, power switch, protective door safety cover of the machine at will, so as to prevent the sensor operating incorrectly. check 100% of the printed PCB

4.Operators need regular maintenance, Yamaha placement machine maintains the machine; machine repair maintenance must be stopped there is a technician engineer nearby to operate; the equipment is only auscultated during production, the equipment engineer is notified when the machine is abnormal After processing, after the problem is solved, the moving parts should be returned to their original positions.

What are the problems encountered when using second-hand placement machine?

Even with very good quality new equipment, various problems may be encountered during use. If a failure is repaired in time, it will affect the efficiency of the work. Therefore, it is naturally possible for second-hand placement machines to encounter problems in use. In order to ensure the practical convenience of everyone, today's Yamaha placement machine editor will analyze the problems you may encounter when using second-hand placement machines.

First of all, during use, the second-hand placement machine may work properly. If this happens, do n’t worry about it, check the power supply, because it may be that your power plug is plugged in, of course, it may be voltage The big problem is that there is a problem inside the equipment. At this time, relevant personnel must be contacted for troubleshooting repair.

At the same time, the second-hand mounter will generate heat during use. Everyone will worry that this situation will damage the equipment. In fact, the general heat is caused by the overload of the equipment. If everyone starts to heat up, then everyone will It is necessary to check the internal problems of the equipment repair them in time.

In fact, there are many problems encountered in the use of second-hand placement machines. You must understand them one by one, then solve the problems with the right medicine, so as to ensure the good use of the machine, so as to better display the second-hand placement machine. Application value of tablet machine.