Whether it is an automatic second-hand placement machine a manual placement machine, the used placement machine will often encounter problems in the work. If it does work properly, it will affect the operation of the entire production line. If we know the cause of the problem, we can operate the placement machine more efficiently. The main problems are as follows:

1, what is the reason for working?

Answer: Check the power supply first. The plug is plugged in the voltage is enough. If the voltage is enough, the placement machine cannot be started. The other situation is the internal problem of the fuselage, but this kind of problem is rare. If there is a serious power problem, then only the engineer can solve it.

2, what should I do if the mounter gets hot?

In the past, people often mentioned the problem of heat generation of the mounter, many people were worried that it would damage the machine. In fact, the main reason for the heat is that the mounter is overloaded does affect the operation. If this is the case, stop for a short time, if it starts to heat up, it may be an internal failure of the machine, contact the engineer for debugging.

3, tray feeder failure

The component is properly placed on the station the beam is fed. If the component remains on the station, remove it. Insufficient supply often occurs. As long as the components on the material dropping station overflow, please remove the components the material dropping station by hand before starting.

4. Main reasons countermeasures of throwing

抛 Under normal circumstances, if the material is thrown, stop working first check whether the nozzle is deformed. Clogging, etc., a material problem. If it is , then it may be a system program problem, the factor of interference in the vacuum stable condition is very small, so the program problem is very likely.